Ccam and Acam
Ccam and Acam
Hi I have a k20/k24 and have recently installed ktuner pnd ecu on it with a k20z basemap with boost support. When I’m logging the car it shows ccam degree at 0 and Acam degree also at 0 I have checked wiring of vtc sensor and it had continuity and is wired on the correct pin can you help me on what can be the issue
Re: Ccam and Acam
If you don't have a check engine light then it sounds like you disabled VTC or played with limit settings.
Re: Ccam and Acam
At first it wasn’t showing any errors then it showed P0344 camshaft position intermittent ...:things done so far I have replaced camshaft position sensor, checked wiring I have voltage,ground and continuity on camshaft sensor A wire and ecu ...still unable to resolve the issue
Re: Ccam and Acam
If you have an error you will need to resolve that before you'll have an active system, of course. If you disabled codes related to CAM or VTC that will disable the VTC system, too.
Re: Ccam and Acam
All my issues were resolved i had a bad cam sync plate...there is one last thing i would like to ask while tuning in logs ktuner is removing 10-11 degrees of timing after vtec all over the map. how can i disable knock control to stop ktuner from removing timing.
Re: Ccam and Acam
We can't coach you on tuning, but this might help you calculate. http://www.ktuner.com/KTunerHelp/igniti ... ontrol.htm