If I wanted to retain the ECO button features other than the altering of the throttle map, would I just make the ECO DBW map look the same as the standard DBW map?
Also, if I wanted the throttle map to be strictly linear, how would I set the map? I'm new to this all so all the numbers and buttons on the chart mapping page are a little confusing.
TIA
Retaining ECO button features and setting DBW to be linear
-
- Posts: 12
- Joined: Sat May 11, 2019 2:30 pm
Re: Retaining ECO button features and setting DBW to be line
You can certainly alter ECO DBW with that map if you have access to it.
-
- Posts: 12
- Joined: Sat May 11, 2019 2:30 pm
Re: Retaining ECO button features and setting DBW to be line
I do appear to have access to it, however the map charts for ECO Base and Final appear to be on different scales. Not sure how to make them equal exactly.
***EDIT*** I see why they look different. The ECO base chart is TP/KPH while the Final is TP/RPM. Not sure how to get them to appear on the same scale so I could make them equal.
***EDIT*** I see why they look different. The ECO base chart is TP/KPH while the Final is TP/RPM. Not sure how to get them to appear on the same scale so I could make them equal.
Re: Retaining ECO button features and setting DBW to be line
Final should not match ECO or vice versa. The Final DBW table uses the output of the standard table as it's incoming TP value.