KTuner.com

Hey everyone

05 RSX base. End user board.

Just switched out the intake to an rbc. This deletes the imrc. That gives me 5 wires available to repurpose if possible. I wanted to add a honeywell fuel pressure sensor. Can I use any of this wiring or do I need to run new wires to the ecu?

I only see eld and fuel tank pressure available in the software.

The programmable inputs you can use, including those on the R1 board itself, are shown in preferences.

KTuner wrote:The programmable inputs you can use, including those on the R1 board itself, are shown in preferences.

OK, So I will just need to repin the sensor signal wire to the eld, tank pressure, or one of the four on board positions?

Any available input listed in the software can be used for monitoring sensors, yes!

KTuner wrote:Any available input listed in the software can be used for monitoring sensors, yes!

Thank you sir. I just moved one ecu pin over and used the existing wiring and I have a fuel pressure sensor up and running. Easy stuff. Thanks again.

No problem.