Hey everyone
05 RSX base. End user board.
Just switched out the intake to an rbc. This deletes the imrc. That gives me 5 wires available to repurpose if possible. I wanted to add a honeywell fuel pressure sensor. Can I use any of this wiring or do I need to run new wires to the ecu?
I only see eld and fuel tank pressure available in the software.
Repurpose IMRC Wiring
Re: Repurpose IMRC Wiring
The programmable inputs you can use, including those on the R1 board itself, are shown in preferences.
-
- Posts: 21
- Joined: Thu Nov 08, 2018 1:00 am
Re: Repurpose IMRC Wiring
OK, So I will just need to repin the sensor signal wire to the eld, tank pressure, or one of the four on board positions?KTuner wrote:The programmable inputs you can use, including those on the R1 board itself, are shown in preferences.
Re: Repurpose IMRC Wiring
Any available input listed in the software can be used for monitoring sensors, yes!
-
- Posts: 21
- Joined: Thu Nov 08, 2018 1:00 am
Re: Repurpose IMRC Wiring
Thank you sir. I just moved one ecu pin over and used the existing wiring and I have a fuel pressure sensor up and running. Easy stuff. Thanks again.KTuner wrote:Any available input listed in the software can be used for monitoring sensors, yes!
Re: Repurpose IMRC Wiring
No problem.