Hello everyone,
I have an 07 Honda Civic 8th Gen Si and I am in the middle of getting it tuned right now but I am stuck. I did my first datalog and everything came out great and the tuner was able to open it up and send me revision 2, well when I go to do my datalog under rev 2, my tuner is unable to open the file, it says failed to load. I drive my car around for about 20-30 minutes, right when my car warms up at the right temperature I hit record and then do what I need to do. When I get back into my garage, I make sure to stop the recording and save the datalog before turning my car off but I notice it saves it by itself and then I have to move the file so that I can send it to the tuner. I am not sure what I am doing wrong (if anything). I am just so frustrated with this because the first time I ever tuned my other SI, everything went so smoothly. If anyone has any input, I would greatly appreciate it. I made sure to update everything on my computer and make sure that ktuner is updated as well. Also I've noticed when I have Ktuner running, at the bottom of the left hand on my screen it says logging (I am not sure if that has to do with anything?), and when I do a datalog, I always hit record and then stop recording before I turn my vehicle off. Thank you everyone.
Datalogging Issues
Re: Datalogging Issues
The software would save a KTuner datalog file if you save datalog, not export to CSV, or have it set to a folder so it can automatically save datalogs recorded in the software. You can open the file with KTuner to verify you saved it properly before sending it to him.