1985 Toyota Pickup Wiring

[poopoo]

Hello, I'm starting to wire up the K24 I'm installing in a toyota pickup.



I have a 2005 RSX ECU with Ktuner installed. When I apply power to the ECU +12 on pins 2,3 and ground Pins 4,5 using a bench power supply I can connect the laptop and communicate with the ECU, but the anti-theft tab in the software has no content whatsoever. My intent was to power up the ECU and change these settings before hooking up all the other wires.

Strangely when I attempt to power up the ECU in the truck using the IG1, and MRLY I get 12V to pins A2, and A3, but the ECU is not able to communicate with the software at all.

Anyone have an idea what is going on?

Thank you,

[KTuner]

The anti-theft feature is not available to you currently. If you've disabled immobilizer and everything is hooked up it will start.

[poopoo]

Thank you, I was confused between anti-theft and immobilizer.

Today the truck started and ran okay at idle with an RSX base code. Since I have a K24A2, but elected to replace the DBW with an accord TB is there a way to use all the TSX maps but with IAC instead of DBW? It would be awesome to start with the correct base maps.

Adam

[KTuner]

When you go to File>New there's two tunes labeled "PRB TSX Swap Tune" 1/2 in the 05-06 RSX Type-S section.

[poopoo]

oh! duh. thank you. Great product so far.

[KTuner]

No problem

[poopoo]

IT RUNS



Is there a procedure to calibrate the TPS? I click the calibrate 0% button and nothing appears to happen. TPS read always comes back 80% when I depress the pedal fully. I'm worried the ECU does not know that 80% is really 100% now.

Also is there a way for me to adjust the cooling fan control? I'm hoping to use an ECU controlled relay instead of temperature switch. I see it is pin E19, can I adjust the temp? what is the factory setting?

Do yall get about 14.7-14.9 AFR on the WBO2 after idling a few minutes?

Thanks,

Adam

[KTuner]

You're calibrating 0%. The factory RSX sensor doesn't go to 100% either. You can adjust WOT TPS settings in the closed loop settings.

Fan Control is under Factory Output Controls.

Your target air/fuel for closed loop can be adjusted in the closed loop settings.