WOT enrichment
Posted: Tue May 23, 2023 2:16 pm
2013 ACURA TL SH-AWD 6MT.
Hello
I've only gotten familiar with hondata over the years, but ktuner was the only option for this TL .
My question is, during WOT is the ecu not supposed to follow the WOT enrichment table whether it goes leaner than 14.7 or richer?
I've always put a small lean section for highway cruising as I commute a ton for work, but I can't seem to get this vehicle to follow the A/F tables I've made.
With the hondata I made it always in WOT by lowering the map and tps values near or at 0 to command WOT, then it would follow my A/F tables and do what I wanted it to making it lean for cruising.
So i've done that here too and made the A/F tables- WOT cat heating as well as WOT enrichment- the same and even raised (leaned) the numbers on the target lambda in closed loop settings (assuming it wouldn't even matter and it will follow the WOT tables anyway and not be lean if in CL still, which it isn't), but it never goes into the leaner section, not even sure if it's following the WOT A/F ratios set by myself yet to be honest.
I also don't have the option to click on disabling Closed loop or WOT based on map only, wondering why?
Thanks in advance for any help.
Hello
I've only gotten familiar with hondata over the years, but ktuner was the only option for this TL .
My question is, during WOT is the ecu not supposed to follow the WOT enrichment table whether it goes leaner than 14.7 or richer?
I've always put a small lean section for highway cruising as I commute a ton for work, but I can't seem to get this vehicle to follow the A/F tables I've made.
With the hondata I made it always in WOT by lowering the map and tps values near or at 0 to command WOT, then it would follow my A/F tables and do what I wanted it to making it lean for cruising.
So i've done that here too and made the A/F tables- WOT cat heating as well as WOT enrichment- the same and even raised (leaned) the numbers on the target lambda in closed loop settings (assuming it wouldn't even matter and it will follow the WOT tables anyway and not be lean if in CL still, which it isn't), but it never goes into the leaner section, not even sure if it's following the WOT A/F ratios set by myself yet to be honest.
I also don't have the option to click on disabling Closed loop or WOT based on map only, wondering why?
Thanks in advance for any help.