K24a4 base map causing temp gauge not working
Posted: Tue Jun 14, 2016 1:56 am
I have a 05 rsx type S and swap a stock K24a4 to get it running. I finally got a chance to use ktuner and load a K24a4 map. Motor runs good, but temp gauge is not working on cluster, but it does read on the laptop. Reload stock K20z map and temp gauge works correctly.
Is there a way to have a stock K24a4 map added to the list on the RSX side?
I was planning to copy and paste the k24a4 ign, fuel, map over to tsx map under the rsx. Notice that you can't copy and paste any values.
Is there any other options. Other than start tuning from scratch.
Is there a way to have a stock K24a4 map added to the list on the RSX side?
I was planning to copy and paste the k24a4 ign, fuel, map over to tsx map under the rsx. Notice that you can't copy and paste any values.
Is there any other options. Other than start tuning from scratch.