KTuner.com

so im planning on swapping in a stock k24a2 long block in my 05 type s. do i just need to load the base map for the k24a2 thats on the list or do i still need to get it tuned to run smooth. i dont want to run rich or lean once i get the car running. i will be getting it tuned once i get and i/h/e. will i be fine with the base map on the program

Basemaps are just meant as a starting point. There's a good chance it will run the setup, but you should consult a tuner to verify or fine tune as necessary.

OK, if I have a 05-06 base auto RSX - should I stick only with PND Auto basemaps as a starting point and tune from there, or other basemaps (PND MT, PRB, etc..) can be used too?

thank you

If you have an AT and run a MT program your transmission will not function. Stick to the AT basemaps.

so i will be able to drive the car for a while till i get time to get the tune. nearest tuner i have is about an hour away from me

You can use the software to monitor how the vehicle is performing. If you're not sure what to look for I'd recommend consulting a tuner before hammering on it in any capacity.