Page 1 of 1
Programmable Outputs (Water/Methanol Wiring)
Posted: Tue Apr 11, 2017 12:34 pm
by Burton5251
I am looking to run a water/methanol setup and wish to run the activation through Ktuner like many have done with Kpro using the E21 input and E22 output (Nitrous tab). I can not find a schematic on what wires are used for the 6 programmable inputs/outputs that are available. Any input would be greatly appreciated.
Re: Programmable Outputs (Water/Methanol Wiring)
Posted: Tue Apr 11, 2017 12:53 pm
by KTuner
Output Tasks under Factory Output Controls. Each output pin is given. You choose the task that triggers the output in each menu.
Re: Programmable Outputs (Water/Methanol Wiring)
Posted: Tue Jun 20, 2017 8:02 pm
by Burton5251
As we have previously discussed I have set up a input (switch) to activate my water/methanol system.
I am looking to purchase a fail safe (Safe Injection) unit for my system. In the event of no flow it triggers a 12V signal. E16 with 12V applied the ground = off. If 12V is not applied can you confirm that the ground = on?
Re: Programmable Outputs (Water/Methanol Wiring)
Posted: Wed Jun 21, 2017 2:22 am
by KTuner
Each input states what the activation is in the pulldown menu.