Page 1 of 1
I think I messed up.
Posted: Fri Aug 25, 2017 9:10 pm
by BlakeQ95
Hey guys, so I was going to adjust my launch control and after I changed it I clicked upload base code and now my car isn't starting.
I tried recovery and flashing it back to the stock tune but no luck. I'm a newb sorry.
Re: I think I messed up.
Posted: Fri Aug 25, 2017 9:14 pm
by KTuner
Upload basecode reflashed the vehicle. If you have an ECU that's not factory you may need to disable immobilizer as well. That being the case, if it's not your original ECU it won't run on the factory tune.
Re: I think I messed up.
Posted: Fri Aug 25, 2017 9:17 pm
by BlakeQ95
Yes I have the ecu package with end user. It was working a second ago before I tried to mess with the
2 step and after I clicked upload basecode the car wouldn't start anymore.
Re: I think I messed up.
Posted: Fri Aug 25, 2017 9:27 pm
by BlakeQ95
I disabled the immobilizer and it started!!! So thankful for your customer service!
Any idea why that happened??
Re: I think I messed up.
Posted: Fri Aug 25, 2017 9:31 pm
by KTuner
Hey no problem. Glad it was simple.
If you started with a new file the immobilizer is not disabled by default.
Re: I think I messed up.
Posted: Fri Aug 25, 2017 9:35 pm
by BlakeQ95
Ooooooohhhhhhh that makes total sense. Cause everything was coming on and
It was cranking I knew something was just weird about it. So everytime I make changes to a flash i press
Upload basecode?
Re: I think I messed up.
Posted: Fri Aug 25, 2017 9:56 pm
by KTuner
If you're trying to commit what you've changed to the ECU you upload basecode. You should also save your tune file so you can open it back up and continue from where you left off.