I have a CL7R and I tired to load a basemap into the ktuner
I have some issues on the following based on what I tried
K20z1 rsx , k20a3 rsx, K20a jdm rsx: engine start fine, idle is steady but the rpm gauge doesn’t work
K24 usdm tsx: engine start fine, runs fine , engine light on because this is not dbw
Any help will be appreciate, been stuck on this for a long time with an ecu which I cannot use
Thanks
Basemap
Re: Basemap
You're posting in the 03-05 Accord section, but that doesn't seem to be an option you've tried in the software according to this post. Start with that one.
Re: Basemap
it is 05 CL7 Euro R, I also tried the 03-05 accord
It stalled and engine light on
It stalled and engine light on
Re: Basemap
03-05 is drive by cable Accord codebase. If you have a drive by cable ECU listed on the 03-05 Accord page and drive by cable vehicle that'd be the one to use.
Check the error code. Have it properly tuned.
Check the error code. Have it properly tuned.
Re: Basemap
Thanks for the reply
I found out the cam angle on the 03-05 Accord is 0 10 20 30 40, but on the K20 map it suppose to have 0 15 30 45 50.
Is that means I cant use the 50 on the Accord map?
Much appreciate
I found out the cam angle on the 03-05 Accord is 0 10 20 30 40, but on the K20 map it suppose to have 0 15 30 45 50.
Is that means I cant use the 50 on the Accord map?
Much appreciate
Re: Basemap
It's interpolated, so anything passed 40 would use the 40 table.